Arı Crane Machine Industry

ARI Machine And Crane Industry Standard Monorail Cranes

Technical Specifications

1-Crane Group and Principal :• Investigator of the body frame made of steel as a construction. Executive group and the gear wheel is idled. A form of propulsion may be completely two completely as possible. Oil bath gearbox with output pinion gear wheel be driven out is provided.
2-Lifting Gear Group:• Monorail cranes in our company with our own production of C type reducer is used. Shafts and gears in the gear reducer to DIN 3960 According to the norms of hardened steel can be produced by heat treatment and hardening, strain after being subjected to removal of tooth profile is stone. Reducers GG 22 cast iron body. All redüktörlerimiz closed box, and bearing oil bath Guiding type. Gear oil fill, oil level and discharge valve indicator is.
3-Lifting Motors:• Used to remove static engines (Qx1.4) based on safety are selected taking. Standards used in manufacturing motors, three phase, short-circuit-rotor, fully closed, the protection class IP 55, insulation class F , Are asynchronous motor. Dual-speed motors, imported motors, high protection class and the speed of the engine control unit (inverter) motors for our customers' requests are used in accordance with.
4-Drum system: steel pipes or drums which is our standard manufacturing GG 22 and over are made of cast iron to be used according to the rope grooves are opened wide. Drum diameter and the grooves are manufactured according to DIN standards. Hand drum While driven by the hub bearings yataklamalıdır other. During a single rope properly wraps a rope drum mounted guide.
Removal of 5 Rope: • All of our cranes, selected according to DIN standards, tensile strength 180 kg/mm2, and the factor of safety of at least five substantive hemp ropes are used.
6-Coupling system and Pulleys: • Hook DIN 15401-15402 norms forged in steel are not, and can rotate 360 degrees around the axis on the safety latch is located. Single-edged hook upon request or can be chosen as a double-edged. Bearing rollers and rope pulley block hook yataklamalıdır not exit On both sides of the reel spool caps are. caps are.
7-Braking System:• Lifting, lowering, and walking gear brake layout, electromagnetic, compressed springs, pads and adjustable type. Electromagnetic cranes used in our brakes are definitely not affected by power interruptions, electricity was cut off the brake closes and the load does not leave immediately. If you need to download and install hangs on the back brake setting down the nut can be loosened gradually installed.
8-Limit Switches:Hook on the top or bottom of the desired stop point provides. Also the last point of execution in the buffer system to be used in allows the crane to stop without hitting. Two or more of the same number of running rail do not hit each other are used in cranes.
9-Electricity Board and the switching equipment: • Appropriate sizes, the right to protection class IP 55 electrical panels are used. Board materials in electrical switchgear, cable VDE 0100/430 sections' is chosen according to the specified current carrying capacity. AC3 and working conditions of the use of contactors, depending on the class 2-3 years Contact lived according to IEC 158-1 is selected. VDE 0606 part thermal or downloads, Fuses Chosen according to VDE 0636 or ISO-TS certified products are used.
10-Crane Control:push button system for mobile crane or a radio-controlled remote control system is carried out. The energy of the whole system of controls on the crane ensure the safety of the emergency stop button cut is. According to need two speed winches button is used for the double contact.